Tuesday, 10 May 2011

Joining the Engine and Gearbox

New clutch release bearing fitted to the clutch fork.  Lubrication applied as instructed in the clutch kit.

Engine and gearbox fitted together.  New cap head bolts, thread locked and torqued up to the correct amount.

With the Tiger ERA sump fitted the gearbox mounting holes in the lower crank case are no longer present.  Only the upper five bolt holes can be used.  Two dowels are still available to ensure gearbox alignment.  Next job is to crane the engine into the rolling chassis and make good the engine mounts.

No comments:

Post a Comment