Non-slip Pedals

The Tiger floor mounted pedals come with rubber covers, the standard type that are fitted in production cars. However, these are a bit bulky for the restricted space in the drivers footwell. I had some left over skateboard grip tape from another project. I cut pieces and applied them to the brake and clutch pedals. Not sure how durable this will be in use, but it seems fairly tough stuff. The throttle pedal was left as smooth powercoated metal. This will allow easy variations to the throttle settting.

Floor mounted pedals mounted

I am fitting the Tiger floor mounted brake and clutch pedals. First to do is the brake. The brake master cylinder had been mounted previously so, after inserting the pushrod, it was relatively easy to establish where the floor bracket for the pedal would go and hence where the holes needed to be drilled. The pushrod seemed a little long, so in order to maximse leg room in the cockpit I decided to shorten it. In the end I only removed about 5mm. This was to ensure that the pedal still had it's full travel, i.e. the master cylinder bottomed out and the back of the pedal did not foul the bulkhead. Also as the pedal swings the pushrod does not move in a perfectly horizontal plane. It arcs slightly and as such the pushrod cannot be too short or it fouls on the slides of the master cylinder plunger.

The clutch pedal was mounted next. Before drilling the holes this was lined up with the hole in the bulkhead where the clutch cable passes through.



The chassis now needs to be turned over so that larger holes can be drilled in the aluminium floor to allow the nuts to be added to the pedal mounting bolts. Finallly the lock nut can be added to the brake pushrod connector and the stop can be fastened under the rearmost bolt on the brake pedal bracket. This prevent the pedal falling towards the driver and the pushrod falling out of the master cylinder. Not what you want whilst driving!