Intatrim Ranger seats have been installed in the car along with the Tiger provided harnesses. I decided not to opt for colour coded piping on the seats as I think there is already enough contrast with the red harnesses and red detail line on the wheel rims. Also, I was a bit worried that light coloured piping on the seats would quickly discolour. That said I'll have to make sure only clean hands handle the red harnesses.
To mount each seat four M8 cap head bolts were used with nyloc nuts. Bolting through each of the two lengthwise chassis rails and fitted with load spreading washers inside the seat and underneath the car.
To mount each seat four M8 cap head bolts were used with nyloc nuts. Bolting through each of the two lengthwise chassis rails and fitted with load spreading washers inside the seat and underneath the car.
No comments:
Post a Comment