Whilst on the return from a Southern Kit Cars trip to Bletchley Park, I thought I could hear a metallic rattling when the car was idling at junctions. When it was safe to do so, I pulled up at the side of the road and took off the bonnet. I discovered that the upper alternator bracket had failed.
Thankfully, the new bottom bracket is very robust and bolted up very tight. This single bolt was holding the tension in the alternator belt. Aside from worries about the alternator not charging, I was concerned that if the belt started to slip, then the water pump might not function correctly, with the engine potentially overheating. For the rest of the return trip I kept to a steady speed on the main roads. I made it back home, where I was able to look at the bracket failure in more detail. It can be seen where the failure started, from the outside rusty edges and then it has spread across the middle, to completely separate.
For a replacement, I fabricated a new bracket out of a single thick piece of L-section mild steel. It is a little overkill, but I really don't want to have any more alternator bracket issues. Even if I'm carry just that little bit more weight than is necessary. In the future I may trim off some more of the excess metal.
No comments:
Post a Comment