Dashboard

I am using the black GRP dashboard provided by Tiger.  Some people have fixed this on with screws, others with adhesive.  I wanted the clean looks (without screws), but without the permanence of adhesive.  I decided in the end to use regular clear silicon sealant.  My thinking is that it will hold the dashboard firmly, but can be removed later, if needed.  Perhaps by using a very thin long blade.  That technique may damage the dashboard, who knows.  Hopefully I won't need to find out.

I am mounting the digital dash (nearly) flush into the dashboard itself.  A template was cut for the hole required in the dashboard.

Hole cut in dashboard prior to sticking the dashboard to the body shell.

 Same size hole made in the body shell behind the dashboard.

A bracket to hold the digital dash at the right 'depth' was fabricated out of aluminium strip.  This was glued to the back of the dashboard using two healthy blobs of epoxy resin.  Seem to have held very well.

The dashboard had to be filed a bit to get the correct profile to match the scuttle.  I then took a few more millimetres off all round.  This allows a little space around the edge that I will glue some rubber trim on to for IVA.  I've tested a short length, made from the round part of P-trim, and it looks quite smart.

A second bracket was made to brace the lower part of the dashboard - to stop it flapping around.  Once the digital dashboard was mounted the switches were installed for the headlights, etc. Powered up and everything still worked!